How to start the base station power module

4 FAQs about How to start the base station power module

How do I set up a base station?

Set up the base station using either the tripod or T-bar mounting method. You must use an external radio antenna kit for the internal 450 MHz or 900 MHz radio. To avoid interference between the 900 MHz radio and GPRS transmissions, do not mount the external radio antenna within 1 m (3.3 ft) of the GSM antenna.

How do I connect a reciter to a 50W base station?

The DC supply to the reciters is via the system control bus ribbon cable. The connections between modules at the front of a single 50W base station are shown below. The PA is powered by a direct connection from the PMU. The reciter is powered from the PMU via the subrack interconnect board and system control bus ribbon cable.

How do I connect a PC to a base station?

Remove the local area Ethernet connection and connect an Ethernet patch cable between the PC and the base station. You can use either straight through or crossover Ethernet patch cable with the current base station firmware. Click Start > Settings > Control Panel. Double-click Network Connections.

How do I connect a battery to a PMU?

You must connect the DC supply from the battery to the PMU via a fuse or DC-rated circuit breaker with the appropriate rating, as shown in the table below. The circuit breaker must have a contact separation of 3mm, an interrupt capacity of 1000A or more, and an inrush current capability of at least 500A for a minimum of 3.5ms.